Home / Tools / Central AC Installation Cost Calculator
Free Calculator
Central Air Installation Cost Calculator
A typical 2.5 ton central air system in the USA costs about $6,800, with a sample range of $5,200 to $9,500.
All prices on this page are sample estimated USA ranges, not quotes.
Read the full guide: How Much Does It Cost to Install Central Air?
Updated November 14, 2026
Central AC Installation Cost Calculator
Pick your home size and efficiency to see a sample estimated price for a new central air system.
About 2.5 tons for this home size.
In the Southeast and Southwest the federal minimum is 14.3 SEER2, so southern buyers should read the base price as the 14.3 SEER2 price. See the SEER2 table below.
Your estimated cost
$6,800
Sample range: $5,200 (low) to $9,500 (high)
Sample estimated USA range. Your final price depends on home size, system size, efficiency, ductwork, and local labor rates.
Low, typical, and high cost
These bands update with your calculator choices. Use them to plan your budget before you request quotes.
Low
$5,200
A smaller job with basic choices.
Most common
Typical
$6,800
Your selection at typical USA rates.
High
$9,500
A larger job, premium choices, or extra services.
Itemized cost breakdown
Updates live with your calculator choices.
Swipe to see the High column →
| Item | Low | Typical | High |
|---|---|---|---|
| Equipment (condenser, coil) | $2,800 | $3,600 | $5,100 |
| Labor and installation (2.5 ton system, 1 to 2 days) | $1,600 | $2,100 | $2,900 |
| Ductwork modifications | $350 | $500 | $750 |
| Electrical and permits | $250 | $350 | $450 |
| Supplies and refrigerant | $200 | $250 | $300 |
| Totals | $5,200 | $6,800 | $9,500 |
Sample estimated USA ranges. Equipment and labor together are most of the total.
How to estimate in 4 steps
- Measure your home size. Use the cooled floor area to estimate the system size.
- Pick an efficiency. 13.4 SEER2 is the federal minimum in the North, and higher SEER2 units cost more up front and save on bills.
- Run the calculator. Enter home size and efficiency to see your low, typical, and high sample range.
- Get a pro load calculation. Ask an installer to confirm the size, since insulation and windows change the answer.
What affects the price
Home size
Larger homes need larger systems, and system size is the biggest driver of equipment cost. A 2,500 sq ft home needs a much larger unit than a 1,000 sq ft home.
Efficiency rating (SEER2)
Higher SEER2 units cost more to buy and can lower monthly cooling bills over time. A 16 or 18 SEER2 system costs more up front than a 13.4 SEER2 system of the same size. SEER2 is the current federal test rating, and it replaced SEER for new systems.
SEER2 federal minimums by region
Since January 2023, new central air systems must meet these SEER2 minimums, per TrueRepairCost. A quote below the minimum for your region is not a legal new install.
Swipe to see the Minimum column →
| Region | Minimum SEER2 |
|---|---|
| North | 13.4 |
| Southeast | 14.3 (systems under 45,000 BTU) |
| Southwest | 14.3 (systems under 45,000 BTU) |
Source: TrueRepairCost, researched November 9, 2026. A 3 ton unit-only price rises with SEER, as TrueRepairCost lists it: 14 SEER about $1,725 to $3,600, 16 SEER about $2,875 to $6,000, 18 SEER about $4,100 to $7,800, and 21 SEER about $6,325 to $10,800, per TrueRepairCost.
Refrigerant and the indoor coil
New systems use R-454B or R-32 refrigerant. R-454B has a global warming potential of 466, against 2,088 for the older R-410A, per TrueRepairCost. The indoor coil is replaced with the outdoor condenser because the coil must match the new refrigerant and the new SEER2 rating, so a condenser-only swap that keeps an old coil is a false saving.
Replacement or new install
Replacing an old system on existing ducts is a different job from adding air conditioning where there was none. Use the table to see which job you are pricing.
Swipe to see the Sample range column →
| Project type | Sample range |
|---|---|
| Replace AC only | $3,911 to $8,067 |
| Add AC to a furnace and ducts | $3,000 to $10,700 |
| AC plus furnace | $5,000 to $11,000 |
| Heat pump | $3,625 to $10,800 |
| With new ductwork | $7,500 to $16,000 |
Labor is 40 to 60 percent of the total, per TrueRepairCost. Ductwork alone runs $3,000 to $7,500 for 300 linear feet, per Angi.
Worked example: 3.5 ton home in Georgia
TrueRepairCost prices a 3.5 ton Georgia home at $5,650 to $7,650. Georgia is in the Southeast, so the 14.3 SEER2 minimum applies. Our calculator prices a 3.5 ton system at 3.5 x $2,720 = $9,520 before the efficiency multiplier, which is higher because it is a sample model rate, not a Georgia quote, so get a local quote before you budget.
Repair or replace: the $5,000 rule
iBuyer uses a $5,000 rule: multiply the age of the system in years by the cost of the repair, and replace it if the answer is over $5,000. Worked math: 12 years x $500 repair = $6,000, which is over $5,000, so replace. A 12 year old system that needs a $500 repair fails the test, while the same repair on a 5 year old system gives 5 x $500 = $2,500, which passes.
Ductwork condition
Old or leaky ducts may need sealing or repair, which adds labor and material cost. Homes with no ducts at all need a full duct install, which costs far more.
Electrical work
Some homes need a new circuit or panel work to support the new system. An older panel may need an upgrade before the installer can connect the condenser.
Location and permits
Labor rates and permit fees vary by city, and some areas require an inspection. Ask your installer which permits are needed and whether the fee is in the quote.
What is included and what is not
What is included
- Condenser and coil
- Labor and installation
- Basic ductwork modifications
- Refrigerant and supplies
- Old system removal and disposal (most companies include it; if separate, Angi prices it at $25 to $200)
What is not included
- Electrical panel upgrades
- Full duct replacement
- Smart thermostat upgrades
- New ductwork for a home with no ducts
How we estimate
We size the system first, then price it. Tons come from home size divided by 600, rounded to the nearest half ton, with a 1.5 ton floor. The typical price is tons times $2,720 times the efficiency multiplier (1.0 for 13.4 SEER2, 1.15 for 16 SEER2, 1.3 for 18+ SEER2). At the default 1,500 sq ft home that is 2.5 tons x $2,720 x 1.0 = $6,800. Low is 76.5 percent of typical and high is 139.7 percent, so $6,800 gives $5,200 low and $9,500 high after rounding to the nearest $10.
A pro should confirm the size with a load calculation before you buy, since insulation, windows, and climate change the answer.
Hiring a pro checklist
- Get 3 written quotes with the exact condenser and coil models and SEER2 rating listed
- Ask for a Manual J load calculation, not a size guess from square feet alone
- Ask which refrigerant the system uses, R-454B or R-32, and confirm the coil is new
- Ask for a duct leakage test and a written price for any duct repair
- Check the installer license, insurance, and reviews
- Confirm the warranty on parts and labor, and who pulls the permit
Budget tips
- Compare 13.4 and 16 SEER2 total cost over 10 years
- Seal ducts before sizing a new system
- Schedule installation in spring or fall, when Angi says you can save 10 to 15 percent
- Do not count on the federal 25C tax credit: it ended December 31, 2025, under Public Law 119-21, per TrueRepairCost. Check state and utility rebates instead
References
Our estimates use public US cost data as a guide. Labor cost context comes from the US Bureau of Labor Statistics, housing cost context from HUD, remodeling trends from Harvard JCHS, and material prices from Home Depot and Lowes. AC prices in this page also use Angi, TrueRepairCost, and iBuyer. All prices on this page are sample estimated USA ranges, not quotes.
US Bureau of Labor Statistics labor cost data
HUD housing cost data
Harvard JCHS household and remodeling cost research
Home Depot central air equipment prices
Lowes central air equipment prices
Angi central AC installation cost, updated October 22, 2026
TrueRepairCost central AC installation cost, researched November 9, 2026
iBuyer central AC installation cost and the $5,000 repair rule
Related calculators and guides
Frequently asked questions
What size AC do I need?
About 1 ton per 600 sq ft is a rough guide, and a pro should confirm the size.
How long does installation take?
Installation usually takes 1 to 2 days.
Does central air need new ductwork?
Sometimes new ductwork is needed, since old or leaky ducts may need work.
How long does a central AC last?
A central AC lasts about 15 to 20 years.
How much does it cost to replace central AC instead of installing new?
Replacing only the AC costs $3,911 to $8,067, per TrueRepairCost. Adding new ductwork raises the job to $7,500 to $16,000.